Topping L70 Fully Balanced Nested Feedback Composite Headphone Amplifier. The Topping L70 uses the same NFCA modules used in the A90D flagship headphone amplifier. Voltage current hybrid feedback architecture along with Ultra High Gain Feedback technology provides excellent DC and AC performance, ultra low THD and high dynamics range of 146dB. With ultra low output impedance and low noise of 0.3uV which is miles of most other products the L70 provides sufficient specs for driving most headphones. The L70 is compatible with common headphone terminations including 4 pin XLR balanced, 4.4mm balanced, 6.35mm and 3.5mm single ended.

The L70 has a high output level, high output current, low noise and low output impedance. So it can easily drive high impedance headphones as well and very sensitive IEM's with a low floor noise. The L70 also has 2 gain settings which is to meet the needs of may headphones and IEM's.

In the L70 Pre Amp mode you can control your amplifier and speakers with either the remote control or the front panel via the rear outputs and if ground loop noise are an issue we have you covered there with a GND/LIFT switch to help stop this. Also the L70 has a 12volt trigger in and out to switch other devices on and off at the same time (like the E70 Dac or power amplifiers).

Included with the L70 is a Power Lead, Remote control, 6.3mm to 3.5mm adaptor, User Manual.

Electromod offer a 2 year UK warranty with all products sold through us.